Bat Pin Wrench

Supports up to 1-1/4" bat pins and fits under most wheel heads. make sure there is 5cm of clearance below your wheel head.

Material: PETG and High Carbon Steel
Dimensions: 4cm x 4cm x 8cm

Hex Allen Bit: 3/16" x 1" x 1/4"
5/8" Bat Pins: 1/4-20 x 5/8" Socket Head Cap Screws, 304 Stainless Steel
1-1/4" Bat Pins: 1/4-20 x 1-1/4" Socket Head Cap Screws, 304 Stainless Steel
Wingnuts: 1/4"-20 Wingnuts 304 Stainless Steel
Magnets: 5x3mm Rare Earth Magnet

Once you've loosely threaded your wing nut onto your bat pin, you can place both halves of the Bat Pin Wrench around your bat pin and wing nut and twist to firmly tighten. To loosen, simply place the top half onto the pin and loosen.

When you are not using your bat pins, you can store them inside of the wrench. Note: store the bat pins apart from the wingvnuts